Toyota Prius V 2012 Quick Reference Manual page 359

■
Programming a rolling code system (for U.S.A. owners)
If your device is rolling code equipped, follow the steps under the
heading "Programming HomeLink
steps listed below.
STEP 1
Locate the training button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
STEP 2
Press the training button.
Following this step, you have 30 seconds in which to initiate step 3
below.
STEP 3
Press and hold the vehicle's programmed HomeLink
for 2 seconds and release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and hold the button a third time, and
release after 2 seconds. This third press and release will complete
the programming process by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
STEP 4
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
PRIUS v_U (OM47784U)
®
" before proceeding with the
®
signal and operate the garage door.
I n f o r ma t i o n P r o v i d e d b y :
3-5. Other interior features
®
button
®
buttons.
335
3