Appendix
When Setup Fails
Check
Are the lamp indicator and the tempera‐
ture indicator on?
Are all of the indicators on?
The batch setup file may be corrupt, or the USB flash drive or USB
cable may not be connected correctly. Disconnect the USB flash
drive or the USB cable, unplug and then plug in the projector's
power cord, and then try again.
Writing the settings may have failed and an error may have occurred
in the projector's firmware. Stop using the projector, remove the
power plug from the electrical outlet, and contact your local dealer
or the nearest address provided in the Epson Projector Contact List.
55
Remedy