D-Link DAP-1320 User Manual page 30

Section 3 - Web-based Configuration
If you need to use a IPv4 provisioning mechanism for the
Repeater, configure the settings below.
My LAN
Connection
Select the type of LAN connection. If you select Dynamic IP,
is: all the values below will already be set. If you select Static IP,
you need to enter the below values.
IP Address:
Enter the IP address.
Subnet Mask:
Enter the subnet mask.
Gateway
Address: Enter the gateway address.
Primary DNS Enter the IP address of the primary DNS server.
Server:
Secondary
Enter the IP address of the secondary DNS server.
DNS Server:
If you need to use a IPv6 provisioning mechanism for the
Repeater, select the mechanism to use: Link-local. only,.
Static.IPv6,.and.Autoconfiguration. Refer to below and the
next page for details on configuring the different security
modes.
If you selected Link-Local. only, you will see the
following settings:
LAN IPv6 The IPv6 Link-Local Address is the IPv6 Address that you use
tto access the Web-based management interface.
Link-Local
Address:
D-Link DAP-1320 User Manual 27