Sony XAV-62BT Service Manual page 26

XAV-62BT/622/E62BT/E622
1-3. Connection with unit
Procedure:
1. Remove cover referring to "DISASSEMBLY (Page 17)".
2. Insert the 5pin cable into the connector of the MAIN board
(CN402).
Note: Connect 5pin cable after removing the front panel block and DVD
mechanism deck referring to "DISASSEMBLY (Page 17)".
– Top view –
26
CN402
MAIN board
DVD mechanism
deck
3. The switch of RS232-JIG OVERALL ASSY is "L".
H L
4. The communication software is start up.
5. Turn on the main power of unit.
The following log is displayed when starting while connected.
xxxxx Visual Ver[**** ] xxxxx
Techwell Mode
Data Read Format : 'r 005A'+ [Enter]
Data Write Format: 'w 01C4 03'+ [Enter]
DAC Mode
Data Read Format : 'dr0'+ [Enter]
Data Write Format: 'dw1 7D'+ [Enter]
Gerda WB Adjust (TestMode5 only)
Read Drive Value : 'grd'+'r / g / b' [Enter]
Write Drive Value : 'gwd'+'r / g / b'+'value(hex)' [Enter]
Read CutOff Value : 'grc'+'r / g / b' [Enter]
Write CutOff Value : 'gwc'+'r / g / b'+'value(hex)' [Enter]
Flash Write
Save Data to Flash : 'ds'+ [Enter]
Clear Flash Data : 'dc'+ [Enter]
****: Version display