TP-Link TD-W9980 User Manual page 37

TD-W9980
1) Static IP
Select this option if your ISP provides static IP information to you. You should set static IP address,
IP subnet mask, and gateway address in the screen below.
Click Advance, advanced selections of ATM Configuration can be shown.
 Encapsulation Mode: Select the encapsulation mode for the Static IP Address. Here you
can leave it default.
 ATM Qos Type: Select ATM Qos Type provided by ISP, and the type is UBR by default.
WAN Service Setup:
Enable IPv4：Check the box to enable IPv4.

IP Address: Enter the IP address in dotted-decimal notation provided by your ISP.

Subnet Mask: Enter the subnet Mask in dotted-decimal notation provided by your ISP,

usually is 255.255.255.0.
Default Gateway (Optional): Enter the gateway IP address in dotted-decimal notation

provided by your ISP.
 DNS Server/ Secondary DNS Server: Here you can set DNS Server (at least one) manually.
The Route will use this DNS Server for priority.
Enable IPv6: Check the box to enable IPv6.

 IPv6 Address: Enter the IPv6 address provided by your ISP.
N600 Wireless Dual Band Gigabit VDSL2 Modem Router User Guide
Figure 4-11
27