Connecting The Fm And Am (Mw/Lw) Antennas - JVC 0497OFYOTKJEMEN Instructions Manual

Connecting the FM and AM (MW/LW) Antennas

FM Antenna Connections
A
A
N N
T E
A N
7 5
F M IA L
A X
C O
D
G N
A M
T
E X
A M
O P
L O
ANTENNA
FM 75
COAXIAL
GND
AM
LOOP
AM
EXT
AM (MW/LW) Antenna Connections
ANTENNA
FM 75
COAXIAL
GND
AM
LOOP
AM
EXT
1
Note :
Make sure the antenna conductors do not touch any other terminals, connecting cords or power cord. This
could cause poor reception.
B
A
N N
T E
A N
7 5
F M IA L
A X
C O
D
G N
A M
T
E X
A M
O P
L O
FM Antenna
Outdoor FM Antenna
AM (MW/LW) Loop Antenna
3
2
AM (MW/LW) Wire Antenna
A Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75-
ohm COAXIAL terminal as temporary measure.
B Using the Standard Type Connector (Not Supplied)
A standard type connector (IEC or DIN45325) should be
connected to the FM 75-ohm COAXIAL terminal.
Note: Make sure the antenna conductors do not touch any
other terminals, connecting cords or power cord. This
could cause poor reception.
Extend the supplied FM antenna horizontally.
If reception is poor, connect an outdoor FM
antenna.
Before attaching a 75-ohm coaxial cable (the
kind with a round wire going to the outdoor FM
antenna), disconnect the supplied FM antenna.
Turn the loop until you have the best reception.
Snap the tabs on the loop into the slots of the
base to assemble the AM (MW/LW) loop.
If reception is poor, connect an outdoor single vinyl-
covered wire to the AM EXT terminal. (Keep the AM
(MW/LW) loop antenna connected.)
Page 4