andrews Fastflo WHC56 Service Manual page 10

Approximate hot water conditions
37 38 39 40 41 42 43 44 45 46 47 48 50 55 60 65 70 75 80
Set the maximum temperature to suit your own preference.
Washing
Shower, hot water supply, etc.
dishes, etc.
• Hot water temperatures are approximations, and may differ from actual temperatures depending on external
factors, such as the season and length of piping involved.
• When low temperatures are set (for washing dishes, etc.), if the ambient water temperature is already quite
high, it may be difficult to ensure the resultant water temperature is as per the setting.
• When the hot water temperature is adjusted using thermostat-controlled water mixing valves, set the temperature
on the remote controller to about 10°C higher than that required to ensure the appropriate temperature.
When setting high temperatures (60 - 80°C)
• When a high temperature is set, the readout on the right is
shown.
• Please check the temperature displayed before using any hot
water.
Be especially careful using any hot water after any previous
setting of between 60 - 80°C.
Hot water supply, etc.
(Eg.: 60°C)
– 9 –
High temperature
Temperature display
Here
flashes for about 10
seconds to indicate
high temperature.