Error Messages - Panasonic VL-SW250BX Operating Instructions Manual

Error messages

N
Main monitor station/Sub monitor station
Problem
IN USE
PROTECTED PIC
REMOVE PROTECT
(Main monitor station)
PROTECT PIC FULL
CAN NOT PROTECT
(Sub monitor station)
PROTECT FULL
CANT PROTECT
N Sub monitor station only
Problem
CAN NOT CONNECT
REGISTRATION ERROR
Cause & Solution
L The main monitor station or the sub monitor station is in use.
Try again later.
L The image you tried to erase is protected. Release the
protection, then erase it.
LThe number of images you can protect has been exceeded.
You can protect up to 20 images. Release the protection from
other images, then try again.
– Unprotected images will be overwritten by new images.
Cause & Solution
L The sub monitor station is too far from the main monitor
station. Move closer to the main monitor station. If you install a
repeater (optional), the problem may be solved.
L There is an object such as a concrete wall obstructing the
signal. Move to a place without an obstacle. If you install a
repeater (optional), the problem may be solved.
L A microwave or wireless LAN appliance is in use. Move closer
to the main monitor station or use a sub monitor station located
away from those appliances. Try again.
L The registration to the main monitor station is not completed.
Move closer to the main monitor station and register it again.
Help
Page
―
30
31
30
Page
7, 45
7, 45
7
44
51