Bresser GameCam 120 Instruction Manual page 12

SYSTEM" to view the main menu of the camera
without setting a password.
Note: To set a password, see Section 5.2, "Setting
a Password".
The menu navigation of the wildlife camera as
delivered has been set to the English language.
Consequently, you should fi rst set the navigation to
a useful language. To do this, select the "Settings"
menu item using the arrow keys (10) and confi rm
with the "OK" key (11). Then, using the
arrow keys, move to the "Language" item in the
submenu and confi rm this with "OK". Using the
and arrow keys, you can then select your
desired language. After you have confi rmed this
with "OK", the menu navigation will have changed
to the particular language. Then, proceed as
described in this guide.
Using the arrow keys, select the "Photo" menu
item in the main menu (see 6.3) for the photograph
mode, or "Video" (see 6.4) for the video mode.
After you have confi rmed this with "OK", the screen
(14) will fade and the LED (5) will begin to blink.
Over time, the LED blinks faster. When the LED
goes out completely, the camera is operational.
Note: In order to maintain this operating mode, do
not switch the camera off.
5.2 Setting a Password
The password can only be set after switching the
camera on.
After you have confi rmed the pre-set password
and
"000000" (Fig. 6) with "OK" (11), "ENTER SYSTEM"
and "SET PASSWORD" (Fig. 7) appear in the display.
At this point, change to the "SET PASSWORD" item
(which is then highlighted in blue) using the arrow
keys (10) and confi rm with "OK".
"INPUT PASSWORD" appears on the screen.
"000000" is shown below this (Fig. 8). Using the
or arrow keys, enter the desired numeral for each
position. You can move to the next position using
the arrow key. After entering the fi nal numeral,
confi rm the password entry by pressing the "OK"
GB
31