Husqvarna 362XP Workshop Manual page 48

Crankcase seals
1. To replace the crankcase seals, first remove the following
components:
On the flywheel side:
• Recoil starter. See page 16.
• Flywheel. See page 18.
• Generator if fitted. See page 21.
On the clutch side:
• Chain and guide bar. See instruction book.
• Chain guide-plate. See page 12.
• Centrifugal clutch. See page 22.
• Oilpump. See page 24.
2. Screw the appropriate removal tool into the seal and
remove it. For correct removal tool, see item 12 or 13 on
pages 6 and 7. See also fig. 15.
3. Tap home the new seal with a driver (item 11 on pages
6 and 7). See fig. 16.
4. Refit components listed in point 1 above.
Guide bar bolts
1. Drain out the chain oil.
2. Knock through the old guide bar bolt so that it falls into the
oil tank.
3. Remove the bolt from the oil tank.
4. Fasten a steel wire to the thread of the new bolt, thread
the steel wire into the oil tank and out through the bolt hole
in the crankcase. See fig. 17.
5. Pull the steel wire until the bolt comes out through its hole.
6. Pull through the bolt with its nut and spacer between the
nut and crankcase.
7. Check that the bolts square shoulder is seated in its
recess in the crankcase. If necessary, turn the bolt.
8. Refill with chain oil.
46 – English
CRANKCASE AND CRANKSHAFT
Fig. 15
Fig. 16
Fig. 17