Husqvarna 362XP Workshop Manual page 42

Reassembly
Carry out assembly of the piston and cylinder as follows:
NOTE!
Ensure that no dirt or other foreign particles
fall into the crankcase.
1. Oil in the needle roller bearing and fit it in the connecting
rod little end.
2. Locate the piston with the arrow pointing towards the
exhaust port. See fig. 8. Press in the gudgeon pin and fit
the circlip.
3. Fit the inlet manifold to the cylinder. The clamp bolt
should be on the underside. See fig. 9.
4. Locate the gasket on the cylinder base. Push it home so
that it fastens on the sleeve of the cylinder.
5. Oil in the piston ring and the sides of the piston.
6. Compress the piston ring either by hand or using the
piston ring tool 502 50 70-01. See fig. 10. Carefully fit the
cylinder.
7. Fit the four cylinder bolts (C) and tighten them in rotation.
Finally, tighten them to 10 Nm. See fig. 11.
8. Refit the decompression valve (D). See fig. 11. Tighten it
to 15 Nm.
9. Attach the anti-vibration springs (B) to the cylinder. See
fig. 11. Tighten the bolts to 10 Nm.
10.Push home the impulse pipe (A) in the hole on the inlet
manifold. See fig. 11.
11. Fit the spark plug and carry out pressure testing according
to the instructions on the following page.
12.Refit the following components:
• Silencer. See page 14.
• Carburettor. See page 31.
• Cylinder cover. See instruction book.
13.If a new piston and/or cylinder have been fitted, the saw
must be run in for 3-4 hours with the carburettor adjusted
to the basic settings (H=1 and L=1). See carburettor
settings on pages 32 and 33.
40 – English
PISTON AND CYLINDER
Fig. 8
Fig. 9
Fig. 10
C
Fig. 11
D
B
A