http://www.ibm.com/servers/eserver/serverproven/compat/us/eserver.html
BladeCenter Interoperability Guide
http://www.ibm.com/support/docview.wss?uid=psg1MIGR-5073016
With PS700, PS701, and PS702 blades, the following expansion cards require a MSIM in a
BladeCenter H chassis:
QLogic Ethernet and 4 Gb FibreChannel Expansion Card (CFFh)
QLogic 8 Gb Fibre Channel Expansion Card (CFFh)
The MSIM is shown in Figure 1-13.
Note: The MSIM comes standard without any I/O modules installed. They need to be
ordered separately. In addition, the use of MSIM modules requires that all four power
modules be installed in the BladeCenter H chassis.
Left bay for Ethernet
Switch Modules
Figure 1-13 Multi-switch Interconnect Module
Table 1-15 shows MSIM ordering information.
Table 1-15 MSIM ordering information
Description
MSIM for IBM BladeCenter
1.6.7 Multi-switch Interconnect Module for BladeCenter HT
The Multi-switch Interconnect Module for BladeCenter HT (MSIM-HT) is a switch module
container that fits in the high-speed switch bays (bays 7 and 8 or bays 9 and 10) of the
BladeCenter HT chassis. Up to two MSIM s can be installed in the BladeCenter HT. The
MSIM-HT accepts two supported standard switch modules as shown in Figure 1-14 on
page 35.
The MSIM-HT has a reduced number of supported standard I/O modules compared to the
MSIM. I/O module to MSIM-HT compatibility matrixes can be viewed at the following Web
pages.
34
IBM BladeCenter PS700, PS701, and PS702 Technical Overview and Introduction
Right bay for Fibre
Channel Switch
Modules
Part Number
Feature Code
39Y9314
1465