Dvd-Ram Drive; Hdd - Panasonic DMR-EH50P Service Manual

CAUTION:
When replacing Digital P.C.B., pay attention as below.

12.7. DVD-RAM Drive

1. Remove 3 Screws (A) to remove DVD-RAM Drive.
2. Lift up DVD-RAM Drive slightly and remove FFC and
remove Cable between DVD-RAM Drive and Main P.C.B.

12.8. HDD

Handling of HDD
The following precautions should be taken when handling HDD.
1. Never give an impact to HDD. (Even a drop from 1cm height can
be a cause of HDD failure.
2. When placing HDD on a workbench, provide a mat on a bench for
shock absorption and anti-static purposes.
3. When installing HDD, release it from your hands only after
confirming that it is fully set on the chassis.
4. Avoid stacking up HDD.
5. HDD is unstable and easy to fall. Do not stand it on its side face.
6. When handling HDD, hold its side faces to avoid static hazard.
7. Do not place HDD on its wrapping bag after removal. (Prevention
of static hazard
8. Use a screwdriver with low impact and anti-static features.
Note:
When replacing HDD, please make the rear jumper slave or
cable select configuration.
1. Remove ATAPI Connector and HDD Power Connector.
2. Remove 4 Screws (A) to remove HDD Angle with HDD
3. Put HDD with HDD Angle up and down inversely so as
not to give a shock to HDD.
25
DMR-EH50 P / DMR-EH50 PC