Connecting The Am Antenna; Connecting The Speakers - JVC MX-KB1 MX-KB2 Instructions Manual

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit
• Even when connecting an outside AM antenna, keep the indoor AM loop connected.
CAUTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. "Right" / "Left" is labeled
on the rear of the speaker.
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System.
Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.
3. Close each of the terminals.
Right side (rear view)
CAUTIONS:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
5
AM antenna wire (not supplied)
If reception is poor, connect the outside antenna.
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the tabs
on the loop into the slot in the base.
Red Red
Black
Turn the loop until you
have the best reception.
Left side (rear view)
Black