Operating Your Amplifier: Notes And Switching On - MC2 Audio S1400 Operating Instructions Manual

S Series – S1400/800 Operating Instructions
Page 13

Operating Your Amplifier: Notes and Switching On

Read all documentation before operating your equipment and retain all documentation for
future reference.
Do not spill water or other liquids into or on the unit and do not operate the unit while
standing in liquid.
Do not block fan intake or rear ventilation outlets or operate the unit in an environment that
could impede the free flow of air around the unit.
If the unit is used in an extremely dusty or smoky environment, it should be cleaned of any
collected debris at regular intervals. Please also see the notes regarding maintenance on
page 15.
It is important that the power output of your amplifier is matched to the power handling
capacity of your loudspeaker. If not, damage to the loudspeaker could occur.
Switching On...
At 'switch-on' the protection circuit will initially activate whilst the circuits stabilise.
Assuming no faults are detected after a few seconds only the Power LED (and Signal
indicators if signal is applied) will illuminate.