Table of Contents
Advertisement
Page 10
Connecting To Your Amplifier: Inputs and Link Outs
Inputs and Links - The input and link outputs are made via 3-pin XLR connectors, which are
electronically balanced and should be connected via a high grade twin core screened cable,
as follows:
The amplifier is designed to operate with fully balanced equipment and ground loops or loss
of performance may be experienced if connected to unbalanced sources. If it is unavoidable
however, the following wiring should be used. The cable should still be twin core plus screen.
PIN1:
Screen - connected to the chassis of the unbalanced equipment - or left disconnected
at the unbalanced end.
PIN2:
Hot (signal +)
PIN3:
Cold (ground 0V)
NOTE: This amplifier is wired to the latest industry recommendations. PIN1 is connected
directly to the chassis/mains earth. If ground loops (mains hum) are encountered remove the
screen connection from the other end of the cable and leave it open circuit. If problems
persist, consult your dealer/supplier.
DO NOT TAMPER WITH OR ALTER ANY GROUND (EARTH) CONNECTIONS INSIDE THE
AMPLIFIER.
For bridged operation input should be made to channel A only and the rear panel switch set
for bridged mode.
For link outputs the following wiring should be used:
Note that link outputs are purely passive and are hardwired across the inputs, so will
continue to function even if the amplifier is turned off.
S Series – S1400/800 Operating Instructions
PIN1: Screen (see note)
PIN2: Hot (signal +)
PIN3: Cold (signal -)
PIN1: Screen (see note)
PIN2: Hot (signal +)
PIN3: Cold (signal -)
Hide quick links:
Advertisement
Table of Contents
