Operation Mode - LG AS-W2463RH2 Manuals

Operation
The controls will look like the following.
5
6
4
2
7
ON OFF
11
8
13
15

Operation Mode

Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
Copyright ©2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Signal transmitter
1
3
10
CANCEL
9
SET
12
AUTO CLEAN
17
18
14
16
Flip-up door
(opened)
)
1. START/STOP BUTTON
Operation starts when this button is pressed and
stops when the button is pressed again.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps low,
medium, high and CHAOS.
5. JET COOL / HEAT
Used to start or stop the speed cooling or heating.
(Speed cooling or heating operates super high
fan speed in cooling or heating mode.)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and set
the desired up/down airflow direction.
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
8. TIME SETTING BUTTONS
Used to adjust the time.
9. TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained
and to cancel the Timer operation.
10. SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
11. ENERGY-SAVING COOLING MODE BUTTON
(OPTIONAL)
Used to set Energy-Save in cooling mode.
12. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. NEO PLASMA(OPTIONAL)
Used to start or stop the plasma-purification function.
14. HORIZONTAL AIRFLOW DIRECTION CONTROL
BUTTON (NOT ON ALL MODELS)
Used to set the desired horizontal airflow direction.
15. RESET BUTTON
Used prior to resetting time or after replacing batteries.
16. 2ND F BUTTON
Used prior to using modes printed in blue at the bottom of
buttons.
17. AUTO CLEAN(OPTIONAL)
Used to set Auto Clean mode.
18. HEATER(OPTIONAL)
- 40 -
LGE Internal Use Only