Initial Setup Using Existing Dhcp Server - NETGEAR WFS709TP Quick Start Manual

Initial Setup using existing DHCP server

Most existing networks will have already a device offering IP addressing via DHCP, so for this deployment
example, we will assume there is an existing DHCP server in the network and we will use it to allow
communication between the WFS709TP controller and the Access Points.
Log to the controller by accessing it through it's default IP address, 192.168.0.250, and configure the
initial settings. Please note that if your PC is in a different network than 192.168.0.0/24 you will need to
change your PC's IP address to match. If you choose to change the default IP address of the controller
to one in a different network, you will need to ensure the IP address of your PC is in that same network.