NETGEAR WFS709TP Quick Start Manual page 7

Prosafe smart wireless controller

Hide thumbs Also See for WFS709TP:

Even though there are access points connected to the controller, they will not be detected. Without the

DHCP server in the current network, the access points are not able to communicate with the controller.

Until the WFS709TP is configured to offer DHCP or there is another server in the network with that

service, you won't be able to see the Access Points and their test light will remain on.

Go to Configuration -> Advanced -> Controller -> General and then click on the DHCP tab. Fill the

different settings to match your desired configuration.

NOTE: The IP address pool has to be the same network used for the VLAN 1 IP of the controller which

we set up previously.

The default VLAN 1 IP address is 192.168.0.250. This limitation is only relevant

because we're using a single VLAN setup.

Table of Contents