Lanair MX SERIES 250 Installation And Operating Instructions Manual page 10

DIMENSIONS:
MX-250 Height: 36" Width: 46" Depth: 48"
MX-300 Height: 36" Width: 46" Depth: 48"
FIRING CAPACITIES:
MX-250 Nozzle @ 1.79 gallons/hour, No. 2 fuel oil/used crankcase oil
MX-300 Nozzle @ 2.14 gallons/hour, No. 2 fuel oil/used crankcase oil
MINIMUM CLEARANCE TO COMBUSTIBLES:
Top . . . . . . . . . . . . . . . . . . . . . . . . 6"
Sides . . . . . . . . . . . . . . . . . . . . . 18"
Burner Side . . . . . . . . . . . . . . . 38"
Front . . . . . . . . . . . . . . . . . . . . . 60"
THIS HEATER IS DESIGNED TO BURN THE FOLLOWING APPROVED FUELS:
Used 5W through 50W Crankcase Oils
No. 1 and No. 2 Fuel Oils
This heater is not designed for attachment or use with ductwork.
Do not attempt to start the burner when excess oil, oil vapor, or fumes have
accumulated! Never press the red button on the oil primary control more than
twice! This could cause excess vapor, or fuel to ignite causing damage to the
heater and/or chimney.
Do not store or use gasoline, or any other
heater.
This heater is not designed for use in hazardous atmospheres such as: aint Shops, Feed
Mills, installations
WARNING!
Lanair heaters rely on natural draft. Do
in the heaters chimney
!
y exhaust fans, (car exhaust, paint
o ercome a do
required exhaust fans are used (consult your heating contractor).
Section 1 - General Specifications & Hazards
re explosi e or
occur in
draft (positi e pressure). An adequate make-up air system is
Visit our website at: www.lanair.com
9
Weight: 630 LBS
Weight: 630 LBS
Chimney Connector . . . . .18"
Rear . . . . . . . . . . . . . . . . . . . . . 6"
Bottom . . . . . . . . . . . . . . . . 24"
liquid and/or apors near this
conditions are present or could occur.
drafts (positi e pressures)
re negati e pressures are created
s, etc). Do not try to use a po er ent to