Alfa Romeo 156 GTA Owner's Manual page 182

– Screw again the element inside the
valve with the tool (D).
– Use the appropriate lever (E) to insert
and clamp the air compressor pipe (F) to
the tyre valve.
– Start the engine, insert the plug (G)
in the lighter (or current socket, where fit-
ted) and inflate the tyre according to the
right pressure value (see "Cold inflation pres-
sures" in the "Technical specifications" chap-
ter). You are advised to check the tyre pres-
sure value on the pressure gauge (H) with
the compressor off, in order to have a more
accurate reading.
fig. 14
If it is not possible to reach the prescribed
pressure, move the car forwards or back-
wards for about 10 metres, so that the seal-
er is distributed inside the tyre, then repeat
inflation.
If, in spite of the last operation, the pre-
scribed pressure is not achieved, do not
move the vehicle and contact Alfa Romeo
Authorized Services.
Once the correct tyre pressure has been
reached, start driving immediately so that
the sealer is distributed evenly inside the
tyre.
A0B0335m
fig. 15
WARNING
Place the sticker in a posi-
tion where it can be clear-
ly seen by the driver as a notice
that the tyre has been treated with
the quick repairing kit. Drive care-
fully especially in a bend. Do not
overcome 80 km/h. Avoid sudden
acceleration or braking.
After about 10 minutes, stop and check
the tyre pressure once again; remember to
engage the handbrake.
A0B0423m
fig. 16
A0B0424m
181