Maintenance/Inspection Procedure; Check Before Starting Repairs - Aiwa HV-FX5850 Service Manual

MAINTENANCE/INSPECTION PROCEDURE

1 Check before starting repairs

The following faults can be remedied by cleaning and
oiling. Check the needed lubrication and the conditions of
cleanliness in the unit.
Check with the customer to find out how often the unit is
used, and then determine that the unit is ready for
inspection and maintenance. Check the following parts.
Phenomenon
Color beats Dirt on full-erase head
Poor S/N, no color
Vertical or
Horizontal jitter
Dirt on tape transport system
Low volume,
Dirt on Audio/control head
Sound distorted
Tape does not run.
Tape is slack
In Review and
Clutch Assembly D33K
Unloading (off mode),
Torque reduced
the Tape is rolled up
loosely.
Cleaning Drum and
transport system
NOTE
If locations marked with o do not operate normally after
cleaning, check for wear and replace.
See the EXPLODED VIEWS at the end of this manual as
well as the above illustrations See the Greasing (Page 101)
for the sections to be lubricated and greased.
* No. (1)~(13) Indicates the Tape Path to be traveled from Supply Reel to Take-up Reel.
(4) F/E Head
(3) P1 Post
(6) Drum Assembly
(Video Head)
(5) Base
Assembly P2
(2) Tension Post
(1) Supply Reel
Replace-
Inspection
ment
Dirt on video head
Dirt on video head
Dirt on pinch roller
Fig. C-9-3
Fig. C-9-3 Tape Transport System
F/E Head
o
o
Video Head
o
A/C Head
o
Pinch Roller
o
Belt Capston
Clutch
o
Assembly D33K
-99-
Fig. C-9-1 Top VIEW
Fig. C-9-2 BOTTOM VIEW
(7) Base Assembly P3
(8) A/C Head
(9) P4 Post
(11) Pinch Roller
(12) Take-up Guide
Post
(10) Capstan Shaft
(13) Take-up Reel