Precaution On Replacing The Vc-417 Board - Sony DCR-HC36 Service Manual

Self-diagnosis Code
Block Detailed
Function Code
E 6 1 0 0
E 6 1 1 0
E 6 1 1 1
E 6 2 0 0
E 6 2 0 1

1-6. PRECAUTION ON REPLACING THE VC-417 BOARD

Exif Model Data Check
When you replace to the repairing board, the written data of repairing board also might be changed to original setting.
When the data has changed because of board replaceing etc, check the data setting (Exif Model Data) is right. If not, rewrite to the right value.
Exif Model Data
Page Address
C D2
C D3
C D4
Writing Method:
1) Select page: 0, address: 01 and set data: 01.
2) Select page: C, address: D2 to D4, and set the Exif Model Data.
Note: To write in the non-volatile memory (EEPROM), press the PAUSE (Write) button each time to set the data.
3) Select page: 0, address: 01, and set data: 00.
DCR-HC36/HC36E_L2
Symptom/State
Difficult to adjust focus
(Cannot initialize focus.)
Zoom operations fault
(Cannot initialize zoom lens.)
Focus lens initializing failure and zoom
lens initializing failure occur simulta-
neously.
Steadyshot function does not work well.
(With pitch angular velocity sensor output
stopped.)
Steadyshot function does not work well.
(With yaw angular velocity sensor output
stopped.)
Data
DCR-HC36 DCR-HC36E
33
36
00
Inspect the lens block focus reset sensor (Pin ql , of CN3701 of VC-
417 board) when focusing is performed when the touch panel is
operated in the focus manual mode and the focus motor drive circuit
(IC3701 of VC-417 board) when the focusing is not performed.
Inspect the lens block zoom reset sensor (Pin qg , of CN3701 of
VC-417 board) when zooming is performed when the zoom switch
is operated and the zoom motor drive circuit (IC3701 of VC-417
board) when zooming is not performed.
Inspect the flexible board for breakage or loose connection.
If not faulty, inspect the focus and zoom motor drive circuit (IC3701of
VC-417 board).
Inspect pitch angular velocity sensor (SE601 of SI-052 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE602 of SI-052 board)
peripheral circuits.
33
36
45
1-4E
Correction