Precaution Of Replacing The Vc-492 Board; Using Service Jig; Process After Fixing Flash Error - Sony DCR-SR190E Service Manual

Digital video camera recorder
Hide thumbs Also See for DCR-SR190E:
Table of Contents

Advertisement

Ver. 1.2 2007.06
1-4. PRECAUTION ON REPLACING THE VC-492 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform "DESTINATION DATA WRITE".
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform "USB SERIAL No. INPUT".

1-5. USING SERVICE JIG

Connect the extension cable between CN4008 on the DA-042 board and CN1005 on the VC-492 board.
DA-042 board (side B)
CN4008
Extension cable (100P)
CN1005
VC-492 board (side B)

1-6. PROCESS AFTER FIXING FLASH ERROR

When "FLASH error" (Self-diagnosis Code E : 91 : 01) occurs, to prevent any abnormal situation caused by high voltage, setting of the flash
is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by execution of "Clear All record-data".
Note: For "Clear All record-data", refer to Service Manual, ADJ ("7. Record Data" of "2-2. SERVICE MODE").
DCR-SR190E/SR200/SR200C/SR200E/SR290E/SR300/SR300C/SR300E_L2
1-6
ENGLISH
JAPANESE
ENGLISH
JAPANESE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents