Sony ILCE-5100 User Manual page 179

In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and
this may cause a malfunction.
Storing under direct sunlight or near a heater
The camera body may become discolored or deformed, and this may cause a
malfunction.
In a location subject to rocking vibration
Near strong magnetic place
In sandy or dusty places
Be careful not to let sand or dust get into the product. This may cause the product to
malfunction, and in some cases this malfunction cannot be repaired.
On operating temperatures
Your product is designed for use under the temperatures between 0°C and 40 °C (32 °F and
104 °F). Shooting in extremely cold or hot places that exceed this range is not
recommended.
On moisture condensation
If the product is brought directly from a cold to a warm location, moisture may condense
inside or outside the product. This moisture condensation may cause a malfunction of the
product.
To prevent moisture condensation when you bring the product directly from a cold to a
warm location, first put it in a plastic bag and seal it to prevent air from entering. Wait for
about an hour until the temperature of the product has reached the ambient temperature.
If moisture condensation occurs, turn off the product and wait about an hour for the
moisture to evaporate. Note that if you attempt to shoot with moisture remaining inside the
lens, you will be unable to record clear images.
On the functions available with the product
This manual describes the functions of 1080 60i-compatible devices and 1080 50i-
compatible devices. To check whether this product is a 1080 60i-compatible device or 1080
50i-compatible device, look for the following marks on the bottom of the product.
1080 60i-compatible device: 60i
1080 50i-compatible device: 50i
Notes for when on board an airplane
In an airplane, set [Airplane Mode] to [On].
On image data compatibility
This product conforms with DCF (Design rule for Camera File system) universal standard
established by JEITA (Japan Electronics and Information Technology Industries