Daily; Cleaning; Weekly; Treadmill Interior - Nautilus Be Strong Commerical T912 Service Manual

SECTION 1: MAINTENANCE

Daily

• Inspect the power cord and walking belt for wear.
• Check the position of the walking belt. Verify it is not rubbing against the frame. The belt should be
evenly spaced on the deck within 0.25 inches of each side rail. Adjust the belt if necessary.
• Check the optional side handrails to ensure they are fastened securely.
• Remove potential hazards from the treadmill area.
��������� ������ ��������

Cleaning

®
Keeping the Nautilus
operation and increase the lifespan of the components.
DRY MOP THE DECK UNDER THE BELT ONLY. DO NOT ADD ANY LUBRICANTS—ADDING
LUBRICANTS CAN RUIN THE PROPRIETARY FRICTION-CONTROL SURFACE.
DO NOT USE DETERGENTS OR CLEANING AGENTS ON ANY PART OF THE DECK.
DO NOT LET LIQUID ENTER THE TREADMILL OR CONTROLLER. IF IT DOES, THE
EQUIPMENT MUST BE INSPECTED AND TESTED FOR SAFETY BY A NAUTILUS
APPROVED TECHNICIAN BEFORE IT CAN BE USED AGAIN.
Daily
• Keep the treadmill and controller free of dust and debris. Use a damp sponge to wipe the exteriors
and walking belt; do not soak surfaces. Dry all surfaces thoroughly.

Weekly

• Elevate the treadmill to maximum incline and vacuum the floor under it to prevent excess dust and
dirt from interfering with operation.
• If the magnetic key is being used, check it for rust. If you detect rust, replace the magnet. Rust on
the magnetic key will cause power-up problems.

Treadmill Interior

DANGEROUS VOLTAGES ARE PRESENT UNDER THE TREADMILL HOOD. EXERCISE
CAUTION WHEN PERFORMING SERVICE TO THE ELECTRICAL COMPONENTS UNDER
THE HOOD.
6
� � � � � � � � �
Commercial series T9 treadmill clean on a regular basis will help to improve
� � � � � � �
� � � � � � �
® -