Connectivity Test/Volume Adjustments - Mitel iLink Installation & User Manual

Connectivity Test:
Step 1: Turn the power switch to ON while holding in the DOWN VOLUME button for 5 seconds.
Step 2: The CHANNEL A and CHANNEL B LEDs should both BLINK ORANGE while trying to connect to
server, once connected both LED's should be SOLID ORANGE.
Step 3: After successful connection and download the LEDs (depending upon which CHANNELS are in use)
will change to SOLID or FLASHING GREEN. This process can take anywhere from seconds to hours depending
upon the size of download.
If this step fails try to power cycle the unit before using the troubleshooting guide or calling your dealer.
Stored Audio & BGM Feedthrough Level Adjustments:
Step 1: Verify CHANNEL A or B (OUT) is connected to either a phone's MOH port, PA amplifier or speaker.
Step 2: While the CHANNEL LED is SOLID GREEN check the audio level of the device connected to the
corresponding OUT jack of the iLink.
Step 3: Depending upon the device the 600Ω/8Ω switch may need to be pushed to better match the impedance of
the device the iLink is driving.
Step 4: To adjust the stored audio output level press the MODE switch until the LEDs match the chart below.
Once they match the chart below then the VOLUME UP and DOWN buttons can be used to adjust the volume.
If no activity is seen after 60 seconds the unit LEDs will return to normal operation.
Adjust CHANNEL "A" volume
Adjust CHANNEL "B" volume
6
888.664.3366
and/or
"A" LED
SOLID GREEN
OFF
888.664.3366
"B" LED
OFF
SOLID GREEN