Installation - Mitel iLink Installation & User Manual

Installation :

Step 1: Wall or shelf mount the unit. Rubber feet, a wall bracket and screws are supplied in the accessory kit.
Step 2: Verify the power switch on rear of unit is set to OFF. Attach the included power pack to a wall or power
strip receptacle, then attach the other end to the jack on the rear of the unit labeled 12VDC.
Step 3: If connecting unit to an amplifier make sure it is turned OFF for this part of the installation.
Step 4: Connect a RCA cable (supplied in the accessory kit) to the CHANNEL A (OUT) jack on the rear of the
unit. Connect the other end of the RCA cable to a phones MOH port, PA amplifier or speaker. For dual output
applications follow the same procedure for the CHANNEL B (OUT).
Step 5: (Optional) For messaging only applications the existing BGM (Background Music) can be fed through
the iLink. Connect the audio source to the CHANNEL A or B (IN) jack(s) on the rear of the unit. This jack must
only be fed signal level audio - ANY AMPLIFIED AUDIO WILL DAMAGE THE UNIT.
Step 6: Connect an Ethernet cable (supplied in the accessory kit) to the LAN jack on the rear of the unit. Connect
the other end to a 10/100 speed switch or hub.
Wiring Diagram
5