Napoleon GI3016-N Installation And Operation Instructions Manual

Napoleon GI3016-N Installation And Operation Instructions Manual

Gas-fired vented room heater

Advertisement

INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS
INSTALLATION AND OPERATION INSTRUCTIONS FOR
GAS-ZERO CLEARANCE WHEN INSTALLED WITH GI-700 KIT (FLUSH FRONT & LOUVRES)
WITHOUT GI-700 KIT INSTALL RECESSED INTO A WOODBURNING NON-COMBUSTIBLE FIREPLACE
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
Installation and service must be performed by a qualified installer, service
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031
GAS INSERT
GAS-FIRED VENTED ROOM HEATER
NATURAL GAS MODEL
PROPANE GAS MODEL
CERTIFICATION LABEL AFFIXED TO UNDERSIDE OF FRESH AIR DAMPER
FOR YOUR SAFETY
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
agency or the gas supplier.
www.napoleonfireplaces.com • ask@napoleon.on.ca
GI3016-N
GI3016-P
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
1
W415-0171 / E / 01.10.05

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GI3016-N and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Napoleon GI3016-N

  • Page 1 Installation and service must be performed by a qualified installer, service agency or the gas supplier. Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031 www.napoleonfireplaces.com • ask@napoleon.on.ca W415-0171 / E / 01.10.05...
  • Page 2: Table Of Contents

    TABLE of CONTENTS PG 2-5 INTRODUCTION 10-11 OPERATION / MAINTENANCE Warranty Operating Instructions General Instructions Fresh Air Damper System Mantle Clearance Maintenance General Information BLOWER INSTALLATION Care of Glass, Enamelled & Plated Parts Blower Replacement Instructions INSTALLATION ADJUSTMENTS Gas Installation Venturi Adjustments Spill Switch Pilot Burner Adjustment...
  • Page 3: Warranty

    After the first year, NAPOLEON will not be responsible for installation, labour or any other costs or expenses related to the reinstallation of a warranted part, and such expenses are not covered by this warranty.
  • Page 4: General Instructions

    The fireplace, when installed, must be electrically con- GENERAL INSTRUCTIONS nected and grounded in accordance with local codes. In Installation practices vary from region to region and it is the absence of local codes, use the current CSA C22.1 important to know the specifics that apply to your area, CANADIAN ELECTRICAL CODE in Canada or the for example: in Massachusetts State: ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United...
  • Page 5: Care Of Glass, Enamelled & Plated Parts

    If struck, it will chip! Touch-up paint is available mended gas fireplace glass cleaner. Thereafter clean as through your Napoleon dealer. required. DO NOT CLEAN GLASS WHEN HOT! If the glass is not kept clean permanent discolouration and / or blem- ishes may result.
  • Page 6: Spill Switch

    Levelling the insert will eliminate rocking or excessive noise SPILL SWITCH when the fan is in operation. Replace the securing screw This is a thermally activated switch, attached to the back of to the front of the dilution plate. the unit and extending up into the dilution draft hood, which senses the change in temperature and shuts down the gas valve in the event of a severe downdraft of air or a FIGURE 5...
  • Page 7: Finishing

    Use only certified PHAZER logs and charcoal embers available from your Napoleon dealer. 3. While supporting the back log, to prevent it from falling forward, set the three smaller logs into the pockets and grooves of the front and back logs, respectively.
  • Page 8 FLUSH GLASS FRONT KIT, GI-FF FLUSH LOUVRE KIT, GI-1L Attach the lower glass bracket. FIGURE 12a Seat the glass inside the bracket and using two screws attach the SIDE VIEW UPPER LOUVRE upper glass bracket, as shown. LOUVRE CLIP FLASHING SURROUND KITS, GI-900 / GI-909 Assemble the flashing and mount to the inside of the outer shell using 4 securing screws (supplied with the louvre kit).
  • Page 9 ORNAMENTAL FLUSH INSETS, GI-OI FIGURE 17 Assemble the flashing and mount to the inside of the outer shell using 4 securing screws and spacers (supplied) as shown. Hook the ornamental inlays over the spacers. FIGURES 15 LOWER UPPER FIGURE 18 ORNAMENTAL BAY INSETS, GI-OI FIGURE 19 BAY GLASS FRONT, GI-BF...
  • Page 10: Operation / Maintenance

    OPERATION / MAINTENANCE OPERATING INSTRUCTIONS FRESH AIR DAMPER SYSTEM If your masonry fireplace is equipped with a fresh air inlet When lit for the first time, the stove will emit a slight odour in the floor of the firebrick chamber, the insert is able to for a few hours.
  • Page 11: Maintenance

    A 5 to 10 second total light-up period is satisfactory. If 1. In order to properly clean the burner and pilot assembly, ignition takes longer, consult your Napoleon dealer / dis- remove the logs to expose both assemblies. tributor.
  • Page 12: Replacements

    REPLACEMENTS Contact your dealer for questions concerning prices and When ordering replacement parts always give the following availability of replacement parts. Normally all parts can be information: ordered through your Napoleon dealer or distributor. 1. M & S ODEL ERIAL UMBER OF FIREPLACE 2.
  • Page 13 W415-0171 / E / 01.10.05...
  • Page 14: Trouble Shooting Guide

    TROUBLE SHOOTING GUIDE EFORE ATTEMPTING TO TROUBLESHOOT PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR REMOVED SYMPTOM PROBLEM TEST SOLUTION Pilot goes out when the A - System is not correctly - purge the gas line with the glass door removed. gas knob is released.
  • Page 15 SYMPTOM PROBLEM TEST SOLUTION Main burner goes out; A - Refer to "Main burner goes out; pilot stays on" pilot goes out. B - Chimney down-drafting - wait ten minutes. Shut off all exhaust fans in the house (ie: kitchen and bathrooms), furnace, and clothes dryer. Open windows and/or doors.
  • Page 16 W415-0171 / E / 01.10.05...

This manual is also suitable for:

Gi3016-p

Table of Contents

Save PDF