Napoleon GI3016-N Installation And Operation Instructions Manual
Gas-fired vented room heater
Hide thumbs
Also See for GI3016-N:
- Installation and operation instructions manual (16 pages) ,
- Installation and operation instructions manual (16 pages)
Table of Contents
Advertisement
INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.33 AND ANSI Z21.88 RESPECTIVELY FOR VENTED GAS FIREPLACE HEATERS
GAS-ZERO CLEARANCE WHEN INSTALLED WITH GI-700 KIT (FLUSH FRONT & LOUVRES)
WITHOUT GI-700 KIT INSTALL RECESSED INTO A WOODBURNING NON-COMBUSTIBLE FIREPLACE
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity of
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
Installation and service must be performed by a qualified installer, service agency
Fax: (705)722-6031
Email: ask@napoleon.on.ca
Web: www.napoleonfireplaces.com
GAS INSERT
INSTALLATION AND OPERATION INSTRUCTIONS FOR
GAS-FIRED VENTED ROOM HEATER
NATURAL GAS MODEL
PROPANE GAS MODEL
CERTIFICATION LABEL AFFIXED TO UNDERSIDE OF FRESH AIR DAMPER
FOR YOUR SAFETY
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
or the gas supplier.
Wolf Steel Ltd., 24 Napoleon Rd.,
Barrie, On., Canada L4M 4Y8 (705)721-1212
R-2000
GI3016-N
GI3016-P
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppli-
er's instructions.
• If you cannot reach your gas supplier, call
the fire department.
1
W415-0171 / C / 06.11.02
Advertisement
Table of Contents
Related Manuals for Napoleon GI3016-N
Summary of Contents for Napoleon GI3016-N
- Page 1 • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. Wolf Steel Ltd., 24 Napoleon Rd., Barrie, On., Canada L4M 4Y8 (705)721-1212 Fax: (705)722-6031 Email: ask@napoleon.on.ca R-2000 Web: www.napoleonfireplaces.com...
-
Page 2: Conditions And Limitations
After the first year, NAPOLEON will not be responsible for installation, labour or any other costs or expenses related to the reinstallation of a warranted part, and such expenses are not covered by this warranty. - Page 3 TABLE of CONTENTS PG 2-4 INTRODUCTION 10-11 OPERATION / MAINTENANCE Warranty Operating Instructions General Instructions Fresh Air Damper System Mantle Clearance Maintenance BLOWER INSTALLATION General Information Care of Glass, Enamelled & Plated Parts Blower Replacement Instructions INSTALLATION ADJUSTMENTS Gas Installation Pilot Burner Adjustment Spill Switch Venturi Adjustments...
-
Page 4: General Instructions
If struck, it will chip! Touch-up paint is available MAXIMUM HORIZONTAL EXTENSION IS INCHES through your Napoleon dealer. Objects placed in front of the fireplace must be kept a The glass is 3/16" ceramic glass available from your Na- minimum of 48"... -
Page 5: Installation
INSTALLATION FIGURE 4 Levelling the insert will eliminate rocking or excessive FIGURE 2 noise when the fan is in operation. Replace the securing screw to the front of the dilution plate. FIGURE 5 Install rigid black pipe, a flex connector, if local codes per- mit, or 1/2"... -
Page 6: Spill Switch
SPILL SWITCH This is a thermally activated switch, attached to the back of the unit and extending up into the dilution draft hood, which FIGURE 8 senses the change in temperature and shuts down the gas valve in the event of a severe downdraft of air or a blocked or disconnected vent. -
Page 7: Log Placement Instructions
Use only certified PHAZER logs and char- notch situated at the lower left of the back log should be coal embers available from your Napoleon dealer. centred evenly above the pilot assembly. 3. While supporting the back log, to prevent it from falling forward, set the three smaller logs into the pockets and grooves of the front and back logs, respectively. -
Page 8: Logo Placement
GLASS & OPTIONAL KIT INSTALLATIONS FLUSH FRONT LOUVRES, GI-LK, GI-LPB, GI-LAB, GI-LG: Install the louvres and louvre assembly as illus- FLUSH GLASS FRONT KIT, GI-FF: Attach the lower trated in FIGURES 12a AND 13. glass bracket. Seat the glass inside the bracket and using two screws attach the upper glass bracket, and the upper glass bracket cover as shown. - Page 9 BAY GLASS FRONT, GI-BF: With the bay chas- sis on a flat surface, in- sert the front glass (bot- tom first) and centred to RETAINER TAB the mitred edges of the chassis. Fit the bevelled edge of the each side glass piece tightly to either edge of the FIGURES 15 front glass.
-
Page 10: Fresh Air Damper System
OPERATION / MAINTENANCE OPERATING INSTRUCTIONS FRESH AIR DAMPER SYSTEM When lit for the first time, the stove will emit a slight odour If your masonry fireplace is equipped with a fresh air inlet for a few hours. This is a normal temporary condition in the floor of the firebrick chamber, the insert is able to caused by the curing of the logs and the "burn-in"... -
Page 11: Replacement Blower Installation
A 5 to 10 second total light-up period is satisfactory. If 1. In order to properly clean the burner and pilot assembly, ignition takes longer, consult your Napoleon dealer / dis- remove the logs to expose both assemblies. tributor. -
Page 12: Ordering Replacement Parts
CHARCOAL EMBERS W010-0333 BURNER ASSEMBLY W455-0025 NATURAL GAS PILOT ORIFICE W455-0006 PROPANE GAS PILOT ORIFICE LOUVRES W385-0245 NAPOLEON LOGO W562-0012 DOOR GASKET (2PC - SIDE) GI-LK, GI-LPB, GI-LAB, GI-LG KB 35 VARIABLE SPEED SWITCH ACCESSORIES / OPTIONS PART NO. DESCRIPTION GI-FF... - Page 13 GI 778KT BRICK PANEL KIT W470-0002 ENAMEL TOUCH UP AND BRUSH ( SPECIFY COLOUR GI 700KT ZERO CLEARANCE SHELL 111-KT OUTSIDE AIR KIT W690-0001 MILLIVOLT THERMOSTAT W660-0010 REMOTE CONTROL - ADVANTAGE W660-0011 REMOTE CONTROL - ADVANTAGE PLUS GD 660 WALL SWITCH/20FT WIRE W500-0033 V.S.S.
-
Page 14: Troubleshooting Guide
TROUBLE SHOOTING GUIDE BEFORE ATTEMPTING TO TROUBLE SHOOT, PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR REMOVED. SYMPTOM PROBLEM TEST SOLUTION Pilot goes out when the A - System is not correctly - purge the gas line with the glass door removed. - Page 15 PROBLEM SYMPTOM TEST SOLUTION Main burner goes out; A - Refer to "Main burner goes out; pilot stays on" pilot goes out. B - Chimney down-drafting - wait ten minutes. Shut off all exhaust fans in the house (ie: kitchen and bathrooms), furnace, and clothes dryer. Open windows and/or doors.
- Page 16 Napoleon Fireplace Service History This fireplace must be serviced annually depending on usage. Service Technician Date Dealer Name Service Performed Special Concerns Name...