Table of Contents
Advertisement
Single Signon
To use the Single Signon option, select the checkbox for Use the Windows username and password when available.
When the active profile is using LEAP, PEAP-MSCHAP, PEAP-GTC or EAP-FAST, the SCU ignores the username and
password, if any, saved in the profile. Instead, the username and password used for Windows logon is used. Any certificates
needed for authentication must still be specified in the profile.
Click OK then click Commit.
Pre-Logon Connection
To use the Pre-logon connection, select the checkbox for Enable pre-logon connection. This option is designed to be used
when:
EAP authentication is required for a WLAN connection
l
Single Signon is configured, so the Windows username and password are used as credentials for EAP authentication
l
The WLAN connection needs to be established before the Windows login.
l
Once this option is enabled, the Authentication delay and Association timeout values can be adjusted as necessary. Both
values are specified in milliseconds (ms).
The default authentication delay is 5000 ms and the valid range is 0 - 600,000 ms.
The default association timeout is 10,000 ms and the valid range is 10,000 to 600,000 ms.
Click on the Credentials button to enter the logon credentials.
If using the Windows certificate store:
Check the Use MS store checkbox. The default is to use the Full Trusted Store.
l
To select an individual certificate, click on the Browse button.
l
Uncheck the Use full trusted store checkbox.
l
Select the desired certificate and click Select. You are returned to the Credentials screen.
l
If using the Certs Path option:
Leave the Use MS store box unchecked.
l
Enter the certificate filename in the CA Cert textbox.
l
Click OK then click Commit.
4-21
Advertisement
Table of Contents
