8-Time Setup; 9-Dwell Time Setup - Sentry SE series Manual

SE Series DVR Manual

8-Time Setup

(Main Menu – System Setup – Time Setup)
Time Zone – Select time zone by left clicking on the displayed time zone until the correct one is displayed.
Time Setup – Select Year/Month/Day and Hour/Min/Sec. by left-clicking with the mouse on each number displayed and
then clicking the up/down arrows that appear under each digit, until the correct digits are selected.
Daylight Saving Time – Select Yes or No
Sync. From NTP Server – Select "Yes" if time is to be synchronization with an NTP server. A Network connection is
required to use NTP server. NTP server does not work under network DHCP mode.
NTP Server IP – Enter NTP server's IP Address

9-Dwell Time Setup

(Main Menu – System Set – Dwell Time Setup)
Dwell time is the number of seconds each camera image remains on
the screen before switching to the next when the DVR is in single
camera mode and Dwell Time is enabled.
Enable – set to Yes or No
Dwell Time Setting – Set to a number of seconds
18