Toshiba e-studio2040c Quick Start Manual page 18

Chapter 1 PREPARATIONS
Saving energy when not in use – energy saving modes –
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving Procedure to switch
modes
When a specified period of
Automatic
time
Energy Save
last use of the equipment.
mode
When the [ENERGY SAVER]
button
Sleep mode when a specified period of
time
last use of the equipment.
When the [ENERGY SAVER]
button
Super Sleep button
mode when a specified period of
time
last use of the equipment.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*3 [ENERGY SAVER] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).
*5 Any of the Wireless LAN Module, Bluetooth Module and e-BRIDGE ID Gate.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. For details, refer to the
following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*7 Even if you press the [Power] button, the equipment may not enter into the Super Sleep mode and the power may be turned OFF, depending on the
state of the equipment. For the conditions under which the equipment enters into the Super Sleep mode, refer to the following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
For changing the set period of time for entering into each mode, refer to the following guide:
& MFP Management Guide (PDF): "Chapter 2: SETTING ITEMS (ADMIN)" - "Setting General Functions"
For the European version
Contact your service representative to change the default settings noted above.
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
1
Conditions to enter into
modes
has passed since the
*1
When a particular option
is pressed or is installed or when a
*3
particular protocol
*4 has passed since the enabled.
When a particular option
or the [POWER] is not installed and also
*3
is pressed or when a particular protocol
*7
is disabled.
*6
has passed since the
*4
Status of equipment
the mode
"Saving energy - press
START button. " appears on
—
the touch panel.
The touch panel display
*5
goes off and the [ENERGY
is SAVER] button lights in
*6
green.
Only the MAIN POWER
*5
lamp (red) lights.
Conditions to recover
from the mode
When a button on the
control panel is pressed
*2
or when print data or fax
data are received.
Same as the Automatic
Energy Save mode.
When the [POWER] button
is pressed, when print or
fax data are received
through a wired LAN or
when the time set for
Scheduled Print has come.