Table of Contents
Advertisement
tlead Load Ass'y Replacement
4·7·2. Installation
a. Insert the damper arm tip into between the cas-
sette holder and HL arm, and set the damper to
the head load ass'y. (Refer to Fig. 4·7)
b. Install the main cover. (Refer to 4·5)
c. Make.the head clean. (Refer to 5·11)
Fig.
4·7
Damper Replacement
4-8. HEAD LOAD ASS'V REPLACEMENT
4-8·1. Removal
a. Remove both the FC-9/FC·14 Mounted Baord
and shield plate: (Refer to 4-1)
. b. Remove the main cover. (Refer to 4·5)
c. Manually set the machine into the Disk·In
mode. (Refer to Fig. 4·9 (a) )
Em
d. Remove the damper. (Refer to 4·7)
e. Remove the two screws (PS2.6 x 6) which
fasten the head load ass'y to the chassis so
that an excessive force is not applied to the
head arm, and then remove the head load
ass'y, (Refer to Fig. 4·8 (a) (b»
4-8·2. Installation and Adjustment
a. Manually set the machine into the Disk·In
mode. (Refer to Fig. 4·9 (a) )
b. Pass the harness of the head load ass'y through
the opening of the chassis. (Refer to Fig. 4·8
(a) (b) )
c. Fasten both the head load ass'y and lug termi-
nal to the chassis with the two screws (PS2.6
it
6). (Refer to Fig. 4-8 (a) (b) )
d. Bend one tip of the lug terminal by 90
0
±l~o.
(Refer to Fig. 4-8 (c»
Em
e. Install the damper in place. (Refer to 4-7)
-32-
f. Install both the FC-9/FC-14 Mounted Board
and shield plate in place. (Refer to 4-1)
g. Perform the head clearance adjustment.
(Refer to 5-10)
h. Perform the HL arm height adjustment. (Refer
to 5-9)
i. Install the main cover in place. (Refer to 4·5)
j.
Make the head clean. (Refer to 5·11)
Fig.
4-8
Head Load Ass'y Replacement
Advertisement
Table of Contents
