Chapter 4 - Maintenance; Charging The Battery - EMS TAM-242 Installation And Operating Manual

Table of Contents

Advertisement

Maintenance
4Chapter 4 – Maintenance
CAUTION: THERE IS THE RISK OF EXPLOSION IF THE BATTERY PACK IS
REPLACED BY ONE THAT IS NOT SUPPLIED BY EMS GLOBAL TRACKING, OR
IF THE BATTERY PACK IS ABUSED OR DISPOSED OF INCORRECTLY.
OBSERVE BATTERY SAFETY INFORMATION PRESENT UNDER GENERAL
SAFETY WARNINGS ON PAGE iii.
WARNING: The TAM-242 requires no specific maintenance. The device contains static
sensitive parts. There are no user-serviceable parts or fuses inside the device. Refer
servicing only to qualified service personnel.
Note: Prolonged storage of the unit at high temperatures may cause premature ageing of the battery,
resulting in a reduced battery capacity. The unit should be stored below 40°C where possible.
Dust and finger marks can be removed using a soft damp cloth. Avoid using domestic cleaning
products.

Charging the Battery

Caution: The unit should only be recharged whilst the key switch is in the off position. The unit will
not transmit if switched on whilst recharging. Please refer to Switching Off the Terminal on page 9.
Caution: Only recharge using the supplied charger.
Note: The unit must be fully charged before deployment to enable accurate reporting of the
remaining battery charge capacity. Charging time for a discharged unit will typically be 6 to 8 hours.
To recharge the battery connect the unit to the charger. When discharged the charging time will
typically be 6 to 8 hours. Whilst the unit is charging the LED will either flash to indicate the battery
charge status, or illuminated solid red or orange to indicate a fault. Charge status is indicated as per
the following table:
Please refer to Operational Status on page 10 for more information on the LED functions.
This document contains information that is proprietary and confidential to EMS Global Tracking (one or more of the following: EMS Global Tracking Ltd a nd EMS Technologies
Canada, Ltd), and is supplied on the express condition that it is not to be used for any purpose other than the purpose for which it was issued, nor is it to be copied or
communicated in whole or in part, to any third party other than the recipient organization, without the prior written permission of EMS Global Tracking.
12 of 17
TAM-242/252/262 Installation and Operating Manual
LED Status
Flashing - Red
Flashing - Green
© 2011 EMS Global Tracking Ltd, EMS Technologies Canada Ltd.
Battery Charge Level
Low <90%
Charged >90%
MAN-0059 Issue 4

Advertisement

Table of Contents
loading

Related Products for EMS TAM-242

This manual is also suitable for:

Tam-252Tam-262

Table of Contents