TAM-242/252/262 Installation and Operating Manual
Introduction
What is the TAM-262?
The TAM-262 is a TAM-242 supplied with a panic button on the end of a 3m long cable.
TAM-262 panic button
The panic button is mounted on the end of a cable that mates with the front panel connector on the
TAM-242 unit. See Figure 2-3.
Figure 2-3: TAM-262 Panic button cable
Panic button status reporting
When supplied as part of a TAM-262 kit, the TAM-242 unit will enter an Alert state based on the state
of the panic button. The switch is normally CLOSED and changes to an OPEN state when the switch
is pressed. When the switch status changes from CLOSED to OPEN, an extra position report is
generated and an 'Alert' flag is set in the message. The TAM-242 will then generate further Alert
messages for the next 4 hours at the defined Alert reporting interval. After 4 hours the unit will revert
back to standard tracking messages at the normal reporting interval.
This document contains information that is proprietary and confidential to EMS Global Tracking (one or more of the following: EMS Global Tracking Ltd and EMS Technologies
Canada, Ltd), and is supplied on the express condition that it is not to be used for any purpose other than the purpose for which it was issued, nor is it to be copied or
communicated in whole or in part, to any third party other than the recipient organization, without the prior written permission of EMS Global Tracking.
MAN-0059 Issue 4
© 2011 EMS Global Tracking Ltd, EMS Technologies Canada Ltd.
5 of 17