Operating The Tool - Prime T1000 Operating Instructions Manual

PRIOR TO OPERATING THE TOOL
1. Warning signs should always be posted within the area in which a powder actuated tool is to be used. These
signs should be at least 8" x 10" in size with boldface type that is not less than 1" in height. The sign should state
"Powder Actuated Tool In Use".
2. Approved safety goggles should always be worn by operator or bystander, to protect their eyes from flying
particles. Hearing protection should always be worn by the operator and bystanders when using a powder actu-
ated tool. Other personal safety protection as required should also be used.
3. Never modify or fabricate parts for use in your Powers tool. Use only Powers Fasteners, loads, and tool parts.
4. Hands or other body parts must never be placed in front of muzzle/barrel. Accidental discharge can cause piston
and/or fastener to pass through the operator's hand.
5. Never compress the tool against any part of the body. Serious injury or death may result in the event of an
accidental discharge.
6. Always point tool in a safe direction at all times.
7. Use the tool for its intended purpose only.
PREPARATION FOR LOADING THE TOOL
1. Tools must be checked prior to operating to make sure they are not fully or partially loaded with a powder
load or fastener.
2. To insure safe operation, perform the daily function test described in this manual. Be sure the tool is not
loaded prior to performing this test.
3. Do not operate this tool unless all its parts are in place and operating appropriately. Never attempt to use a mal-
functioning tool. Call 1-800-524-3244 for assistance.
4. Never guess about the suitability of a base material. If you are uncertain about the suitability of a base
material, perform a center punch test.
5. Do not operate the tool until you learn and understand the color code / numbering system used to identify
the power level of powder loads.

OPERATING THE TOOL

1. Only use fasteners and powder loads designed for this tool as supplied by Powers Fasteners.
2. Do not use powder actuated tools in a flammable or an explosive atmosphere.
3. Do not fire a tool without a fastener. The piston will impact the work surface possibly causing serious injury
to the operator or bystanders along with damage to the tool.
4. Do not load the tool until you are ready to make a fastening. Check the power load level before inserting it into
the tool chamber.
5. Fastener must be loaded prior to loading the powder load, to prevent injury to operator or bystander in the
event of an accidental discharge.
6. Do not close tool against work surface. The tool should be manually closed, with hand away from muz-
zle/barrel to prevent accidental discharge.
7. Hold the tool perpendicular to the work surface at all times. Use a spall guard wherever possible. This will limit
the possibility of fastener ricochet which could cause serious injury or death to the operator or bystanders.
8. Always perform a test fastening with the lightest load level designed for use in the tool. If the lightest load
fails to set the fastener, try the next highest load until the proper level is attained. Failure to follow this proce-
dure may cause the fastener to be overpowered. If this occurs, the fastener may fully penetrate the base materi-