Table of Contents
Advertisement
fastener. If excessive force is required, stop and determine why the fastener can not be
inserted. Correct the problem before proceeding.
NOTE: Do not use fasteners longer than 3" as listed in the fastener selection section of
this manual.
3. Make sure the breech is clear. Insert the powder load starting with the lowest power
level. If this Load does not fully set the fastener, try the next higher power level until
the proper level is found.
NOTE: Over driving or over powering a fastener can cause a safety hazard.
4. Pull the barrel all the way back to close the tool. Do not attempt to close the tool by
exerting force on the front of the nose piece. Never place your fingers or hands over
muzzle bushing. The safe position for hands and fingers are as shown in the diagram.
Hands must never be placed in front of the tool muzzle or nose piece. In the event of an
accidental discharge, the piston and/or fastener can pass through the operators hand.
5. Once the tool is in the closed position, place it against the work surface. Hold the
tool firmly with two hands and completely depress the barrel. Then squeeze the trigger.
Always hold the tool perpendicular to the work surface. Hold the tool firmly against the
work surface to avoid excessive recoil. Never depress the tool against anything except
the work surface
NOTE: In the event that the load does not discharge continue to hold the tool de-pressed against the work
surface for at least 30 (thirty) seconds in case of a delayed load discharge. Then carefully remove the load and
dispose of in a can of water or other non flammable liquid. Never attempt to force or pry a load out of a tool
chamber. Do not discard unfired loads into a trash container.
6. To prepare for the next fastening, point the tool in a safe direction. Snap the barrel forward as described
in step 1. This action will eject the spent powder load and properly reset the piston. Always insert a new
fastener before loading powder load in the chamber. Do not attempt to unload or
disassemble a jammed, stuck or broken tool as improper handling may cause it to
discharge and strike operator and/or bystander. A jammed tool must be pointed in a
safe direction at all times. Tag the tool and lock it up. Call your Powers Fasteners
representative for proper assistance.
Safety Precautions
Safety is your primary responsibility when operating any powder actuated tool. You must read and under-
stand the contents of this manual. You must be familiar with all functional and safety requirements of the tool.
It is your responsibility to obtain proper training and a Powers Fasteners operator card prior to using this tool in
compliance with the current American National Standard A10.3 Safety Requirements for Powder Actuated
Fastening Systems and the Federal Occupational Safety and Health Administration Standards (OSHA). Existing
state or local regulations should also be followed. When using this tool, you must have the qualified operators
card in your possession.
Revocation of card - Failure to comply with any of the rules and regulations for safe operation of powder
actuated tools shall be cause for the immediate revocation of your qualified operator card.
The following is a summary of safety precautions to be followed when operating a Powers Fasteners
powder actuated tool. Failure to follow these safety instructions can result in serious injury or death to
operators or bystanders.
Advertisement
Table of Contents
