Prime T1000 Operating Instructions Manual page 13

MODEL T1000
QUALIFIED TOOL OPERATOR EXAMINATION
OPERATOR'S NAME
HOME ADDRESS
yy @@ @@ @@ @@ @@ @@ @@
AGE
@@ @@ @@ @@ @@ @@ yy yy @@ @@ @@ @@ @@ @@ @@ @@
 CHECK THE CORRECT ANSWER.
1 It is necessary to read the Operator's Manual
prior to operating a Powers Fasteners low
velocity tool.
K K
True
2 When fastening into concrete, the base
material should be greater than the shank
penetration by at least:
K K
1 time
3 When operating a powder actuated tool, your
hand should never be placed:
K
around the tool body
Stop
Spall
K
in front of the tool muzzle
K
over the tool handle
4 To determine the suitability of a base material,
use the fastener as a center punch.
• If the fastener is blunted, do not fasten; the
material is too:
K K
soft
• If the fastener penetrates easily, do not fasten;
the material is too:
K K
soft
• If the material cracks or shatters, do not
fasten; the material is too:
K K
soft
DATE OF BIRTH
False
K
2 times 3 times
K
hard brittle
K
hard brittle
K
hard brittle
DATE
5 Unsafe applications for powder actuated tools
may be caused by which of the following?
K
a soft base material
K
improper powder load
K
fastening too close to an unsupported edge
K
a malfunctioning tool
K
fastening into a spalled area
K
fastening through a pre-existing hole
K
all of the above
6 Which one of the following building materials
is not suitable as a receiving material (base
material) for powder actuated fasteners?
K
sheet rock
K
fiberglass
K
all of the above
7 When considering the safety of a particular
application, the operator must think about:
K
the base material
K
the powder load power level
K
the operator's safety
K
the safety of bystanders and fellow workers
K
all of the above
8 The proper loading procedure is: insert fastener
first, powder load second. The fastener should always be
placed in the tool prior to the load.
K K
True False
9 Which one of the following materials is usually
suitable for powder actuated fastenings?
K
poured concrete
K
surface hardened steel
K
wood
K
sheet metal
K
hollow tile
K
glazed brick