Table of Contents
Advertisement
Warranty
All warranties of the products described herein, expressed or implied, including the warranties of mer-
chantability and fitness for particular purposes are specifically excluded, except for the following:
Powers Fasteners will repair or replace at its sole option any tool part, or fastener which within 90 days
after sale by Powers Fasteners or its distributors, is found by Powers Fasteners to be defective in material or
workmanship, normal wear and tear excluded.
This is the sole warranty of Powers Fasteners and the sole remedy available to distributor or buyer.
NOTE — JUST AS NO ONE CAN MERELY READ A BOOK ABOUT DRIVING AN AUTOMOBILE AND THEN HOPE TO RUN IT SAFELY, NO ONE SHOULD ATTEMPT
TO USE ANY POWDER TOOL WITHOUT ADEQUATE, COMPETENT, PERSONAL INSTRUCTION. AND, JUST AS NO AUTOMOBILE INSTRUCTION BOOK OR
INSTRUCTOR CAN FOREWARN A LEARNER AGAINST ALL CONTINGENCIES AND EMERGENCIES, NEITHER CAN POWERS FASTENERS INSTRUCTORS OR
PRINTED INFORMATION DETAIL ALL POSSIBLE CONDITIONS SURROUNDING THE USE OF POWERS TOOLS AND PRODUCTS. THE MANUFACTURER DIS-
CLAIMS RESPONSIBILITY FOR INJURIES TO PERSONS OR PROPERTY WHICH MAY RESULT FROM DISREGARD OF THESE OPERATING INSTRUCTIONS.
Introduction
Thank you for purchasing the Powers T1000 low velocity powder actuated tool. This tool will provide you
with excellent performance provided the steps for proper operation and maintenance are followed. Powder
actuated fastening systems can provide a cost effective method of attaching fixtures for light duty, static load
conditions. The systems provided by Powers Fasteners consist of specially designed fasteners, installation
tools, and powder loads which are designed to function in combination to provide optimum performance.
While powder actuated tools can provide one of the fastest and economical means of fastening, they can
also be dangerous if they are not operated properly.
Prior to operating the T1000 tool, you must be properly trained in the operation and maintenance of this
tool and be issued a Powers Fasteners Qualified Operator Card. When using the tool, you must have this card
in your possession. As part of the training process, you should read and understand the contents of this
instruction manual especially the safety precautions.
Powder actuated tools may be operated only by properly trained operators as described in ANSI Standard
A 10.3, Safety Requirements for Powder Actuated Fastening Systems. For complete tool operation details,
contact your local Powers Fasteners Branch office or distributor for training.
SIZE RANGE
1/2" to 3" pin lengths, .22 caliber
TOOL DESCRIPTION
Trigger actuated, professional grade powder actuated tool. Engineered for high reliability, low maintenance and
speed.This tool uses four levels of power; gray through yellow loads (levels 1-4) and .300, 8mm head fasteners with
lengths of 1/2" through 3" and 1/4"-20 threaded studs.
TECHNICAL DATA
TOOL BODY
Precision Molded Rubber
LOAD TYPE
.22 Caliber
PIN TYPE
Ballistic Point Drive Pin, .300 Head Drive Pin, 1/4"-20 Threaded Stud
T1000
MANUAL CAT. NO. 49132 7/09
PIN LENGTH
1/2" to 3" Total Length
TOOL WEIGHT
3 lbs.
TOOL LENGTH
13"
POWER LEVEL
Gray (1), Brown (2), Green (3),Yellow (4)
Advertisement
Table of Contents
