∗ ∗ ∗ ∗ 29 Ip/Gsm Menu Mode; Communication Device Menu Mode (Pass-Through Programming); ∗ ∗ ∗ ∗ 29 Ip/Gsm Program Mode Procedure - ADT Safewatch Pro 3000EN Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
∗ ∗ ∗ ∗ 29 Communication Device Menu Mode
This mode is for programming an IP, GSM, or IP/GSM Communicator Module using a touchpad. Alternatively, these
options can be programmed via the AlarmNet Direct website. After programming is complete, the module must be
registered with AlarmNet before reporting via the communication device can occur. Refer to the device's instructions for
registration procedures.
NOTE: The module must be set to device address 3.
IMPORTANT: The use of an IP/GSM Communicator
Module requires an AlarmNet–I account. Please obtain the
account information from the central station prior to
programming this module.
Using a Custom English Touchpad as a 7720P
Programming Tool
When programming with ∗29 menu mode, the touchpad
mimics the functions of the 7720P Programming Tool.
See figure to right and table below for 7720P key
functions. Each key has two possible functions: a
normal function and a SHIFT function.
Normal functions: The numeric values labeled
directly on the keys and the left-hand functions
shown in diagram on the ABC keys. To perform a
normal key function, simply press the desired key.
SHIFT functions: Those functions shown in
diagram above the numerical keys and the right-hand
functions shown on the ABC keys. To perform a
SHIFT key function, press SHIFT key (D key), then
press the desired function key (shift function is
indicated by the lit READY LED).
∗ ∗ ∗ ∗ 29 IP/GSM Program Mode Procedure
Press ∗29 while in Data Field Programming mode. The following prompts appear.
E N A B L E I P / G S M ?
0 = N o , 1 = Y e s
1 = P R O G 2 = D I A G
0 = Q U I T
Enable IP/GSM?
0 = no, not using IP or GSM;
1 = yes using IP and/or
GSM module
[∗] to continue
Programming /
Diagnostics Select
1= Prog (program the
IP/GSM options)
2 = Diag (enter diagnostic
mode)
0 = Quit; returns to data
field program mode
∗ ∗ ∗ ∗ 29 IP/GSM Menu Mode
(Pass-Through Programming)
ARMED
READY
SHIFT
FUNCTION
WHEN LIT
7720P Emulation Template for Custom English Touchpads
If using a communication device, enter 1 at this prompt and
enter 1-Prog at the next prompt to program the device. Use
the communication device's Installation Guide for details of
the device's programming prompts and instructions for
registration.
[Default = 0 (no IP and/or GSM)]
Select whether you want to program the communication
device or enter the device's diagnostic mode.
Diagnostic Mode Note: Diagnostic mode option available
only for communicators with firmware version 2.4.16 or
higher.
S E C T I O N
A B C
(A)
1
2
BS/ESC OFF
AWAY
D E F
(B)
4 5
/
TEST
S T X
(C)
7 8
N / Y
INSTANT CODE
(D)
0
SHIFT
READY
SPACE
1 1
3
STAY
6
BYPASS
9
CHIME
#
ENTER
SW4000-012-V0
11-1