Instrument Lighting Dimmer; Headlamp Exit Delay; Daytime Running Lamps - Ford 2015 TRANSIT CONNECT Owner's Manual

INSTRUMENT LIGHTING
DIMMER
E132712
Press it repeatedly or press it and hold it
until the desired level is reached.
Note: If you disconnect the battery or it
loses charge the instrument lighting will
return to its brightest setting.

HEADLAMP EXIT DELAY

After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three
minutes with any door open or 30 seconds
after the last door has been closed. You
can cancel this feature by pulling the
direction indicator toward you again or
switching the ignition on.
Transit Connect (CHC) Canada/United States of America, enUSA, First Printing
Lighting

DAYTIME RUNNING LAMPS

Equipped)
The daytime running lamps system
does not activate the tail lamps and
may not provide adequate lighting
during low visibility driving conditions. Also,
the autolamps switch position may not
activate the headlamps in all low visibility
conditions, such as daytime fog. Always
ensure that your headlamps are switched
to auto or on, as appropriate, during all low
visibility conditions. Failure to do so may
result in a collision.
Type 1 - Conventional (Non-
Configurable)
When you switch the ignition to the on
position and the lighting control is in the
off, autolamps or parking lamp position,
the daytime running lamps will turn on
whenever the headlamps are off. They turn
off only when the headlamps are on.
Type 2 - Configurable
Note: If this type is equipped, you are able
to switch the daytime running lamps on or
off using the information display controls.
See Information Displays (page 84).
When the daytime running lamps are
switched on in the information display and
you switch the ignition to the on position
with the lighting control in the autolamps
position, the daytime running lamps turn
on whenever the headlamps are off.
The other lighting control switch positions
do not activate the daytime running lamps
and can be used to temporarily override
autolamp control.
When switched off in the information
display, the daytime running lamps are off
in all lighting control switch positions.
69
WARNING
(If