Indoor Unit - Panasonic CS-E24LKES Service Manual

11.2. Indoor Unit

11.2.1. How to Fix Installation Plate
The mounting wall is strong and solid enough to prevent it from
the vibration.
Model
E7***, XE7***
E9***, XE9***
485 mm 82 mm 165 mm 158 mm 43 mm 95 mm
E12***, XE12***
E15***, XE15***
E18***, XE18***
E21***, XE21*** 585 mm 82 mm 165 mm 158 mm 169 mm 219 mm
E24***, E28***
The centre of installation plate should be at more than
right and left of the wall.
The distance from installation plate edge to ceiling should more
than .
From installation plate left edge to unit's left side is
From installation plate right edge to unit's right is
B : For left side piping, piping connection for liquid should be
about from this line.
: For left side piping, piping connection for gas should be
about from this line.
1. Mount the installation plate on the wall with 5 screws or
more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using
anchor bolts.)
• Always mount the installation plate horizontally by
aligning the marking-off line with the thread and using a
level gauge.
2. Drill the piping plate hole with ø70 mm hole-core drill.
• Line according to the left and right side of the installation
plate. The meeting point of the extended line is the
center of the hole. Another method is by putting
measuring tape at position as shown in the diagram
above. The hole center is obtained by measuring the
distance namely 128 mm for left and right hole
respectively.
• Drill the piping hole at either the right or the left and the
hole should be slightly slanting to the outdoor side.
Dimension
.
.
11.2.2. To Drill a Hole in the Wall and Install
a Sleeve of Piping
1. Insert the piping sleeve to the hole.
2. Fix the bushing to the sleeve.
3. Cut the sleeve until it extrudes about 15 mm from the
wall.
Caution
When the wall is hollow, please be sure to use the sleeve
for tube ass'y to prevent dangers caused by mice biting
the connecting cable.
4. Finish by sealing the sleeve with putty or caulking
compound at the final stage.
at
11.2.3. Indoor Unit Installation
26