AUTOMATIC ANSWERING
TERM 64 lets you use your Commodore 64 to automatically answer a modem
call.
Follow these simple steps:
1.
Install the AUTOMODEM.
2.
LOAD the terminal program.
3.
RUN the program.
4.
Press the f8 key when the TERMINAL READY prompt appears.
to hold down the SHIFT key to activate f8.
auto-answer screen.
5.
Move the switches on the AUTOMODEM according to the instructions
on the auto-answer screen:
MOVE T-D SWITCH TO D
MOVE 0-A SWITCH TO A
WAITING FOR CALL
NOTE: Press RUN/STOP to get back to the TERMINAL READY screen
if you want to terminate the auto-answer feature.
You do not need to be near your computer to receive the call because
automatic answering waits to do this for you.
made, the red light on the AUTOMODEM comes on, and the TERMINAL READY
screen reappears.
MANUAL ANSWERING
To answer an incoming call with the AUTOMODEM, follow these steps:
1.
Install
the AUTOMODEM.
2.
LOAD the terminal program.
3.
RUN the
4.
Set the T-D switch to T (Telephone) so you hear
5.
Set the 0-A switch to A (Answer).
you must be set on 0 (Originate).
6.
Reset the T-D switch to D (Data) when the call comes through.
Now you are ready to receive.
You must remain in Answer mode throughout the transmission.
reset this switch when you want to send a message to the Originating
computer; you can send in Answer mode.
AUTCMODEM
program.
F8 displays the
When the connection is
the phone ring.
The computer
sending data to
Remember
Do not
Page 12