Table of Contents
Advertisement
APPENDIX B
TECHNICAL INFORMATION
AUTOMODEM is a data communications modem.
with the Bell 103 type modems.
in full half duplex, has a switch selectable originate and answer mode and
has a data rate of 0 to 300 BPS (Bits Per Second).
baud rate during the VICTERM I and TERM 64 programs.
Be sure your modem is firmly installed in the proper slot in the back of
your computer.
and test the telephone again.
modem may be the cause of the problem.
repaired (examine your warranty).
responsible for difficulties caused by computer equipment.
TELEPHONE COMPANY NOTIFICATION
Since the AUTOMODEM uses phone lines, the telephone company needs the
following information before the modem is connected to the phone lines:
* The number of the telephone to which the modem is to be connected;
* The FCC registration number;
* The ringer equivalence: 0.1B
MODEM SPECIFICATIONS
Data Rate
Modulation
Line Interface
Transmit Frequency
MARK
SPACE
Transmit Frequency Accuracy
Transmit Level
AUTCMODEM
If you have telephone problems, disconnect the AUTOMODEM
If the telephone now works properly, the
(located on modem decal)
300 bits per second
Frequency Shift Keyed
Direct connect.
ORIG
1270 Hz
1070 Hz
.
01
-12 dbm typical
The AUTOMODEM is compatible
It is a direct connect modem, can operate
Do not use the modem until it is
The telephone company is not
ANSR
2225 Hz
2025 Hz
%
You can change the
F&ge 24
Advertisement
Table of Contents
