Installing The Projector; Precautions For Installation - JVC DLA-S15U Instructions Manual

Installing the Projector

Precautions for Installation

CAUTION
Do not install the projector in the following places :
• There is much water, humidity or dust.
• The projector may be subjected to oil smoke or cigarette smoke.
• On a soft surface such as a carpet or cushion.
• The projector may be subjected to direct sunlight.
• Temperature is high or humidity is low.
Allowable operation temperature range: + 5 C to + 35 C (41 F to 95 F)
Allowable relative humidity range:
Allowable storage temperature range:
When installing the projector, observe the followings:
• Do not use the projector placed on its side.
Avoid using the projector placed on its side. This could cause a malfunction.
• Use the projector within the installed angle.
Avoid using the projector inclined ±30 or more right-to-left or left-to-right. This could cause color variation or harm the lamp
life.
• Do not block the exhaust vents.
Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the
projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the temperature
inside becomes equal to the outside temperature.
Allowable minimum space required
20cm (7 - 7 / ")
8
20% to 80% (no condensation)
–10 C to +60 C (14 F to 140 F)
20cm (7 - 7 / ")
8
20cm (7 - 7 / ")
8
50cm (19 - 3 / ")
4
20cm (7 - 7 / ")
8
15 15