Sharp HT-DD5000W Service Manual page 43

HT-DD5000W
IC808 VHiZR38600/-1: DOLBY AC-3/5.1CH MPEG2 AUDIO DECORDER (ZR38600 ) (2/2)
Terminal Name Input/Output
Pin No.
54 SDD
55 VCC
56* GPIO2
57* GPIO1
58* GPIO0
59 VCC
60 GND
61 SPFRX
62 P/M
63 XTO
64 XTI
65 GND
66 SCKIN
67 VCC
68 GNDA
69 FLTCAP
70 VCCA
71 GND
72* CLKOUT
73* D19
74* D18
75* A17
76* A18
77* A19
78 GND
79 SDC
80 SDB
81 VCC
82 RESET
83 SDA
84 VCC
85 SDE
86 TCK
87 SCK
88 TDI
89 SI
90 GND
91 SCKA
92 WSA/FSA
93 VCC
94 SDF
95 WSB
96* D17
97 SCKB
98* D16
99 SPFTX/SDG
100* D15
In this unit, the terminal with asterisk mark (*) is (open) terminal which is not connected to the outside.
Output Data output for serial ports B, C and D
Used to connect a power supply of +3.3V ±5%
—
Input/Output General-purpose I/O pin
Input/Output General-purpose I/O pin
Input/Output General-purpose I/O pin
Used to connect a power supply of +3.3V ±5%
—
— Ground pin
Input Digital audio interface input terminal
Input Parallel port/memory port mode setting pin
Output Crystal oscillator input/output terminal
Input Crystal oscillator input/output terminal
— Ground pin
Input/Output Group B serial port clock input/output.
Used to connect a power supply of +3.3V ±5%
—
— Ground pin
Input Internal PLL circuit terminal for connecting a capacitor
Used to connect a power supply of +3.3V ±5%
—
— Ground pin
Output Data bas clock output
Input/Output Data bus
Input/Output Data bus
Output Address bus. The address bus is always active.
Output Address bus. The address bus is always active.
Output Address bus. The address bus is always active.
— Ground pin
Output Data output for serial ports B, C and D
Output Data output for serial ports B, C and D
Used to connect a power supply of +3.3V ±5%
—
Input Reset input. Resetting is executed from the specified status and address by the reset signal.
Input Data input for serial ports A, E and F
Used to connect a power supply of +3.3V ±5%
—
Input Data input for serial ports A, E and F
Input ICE interface clock (JTAG)
Input Serial host interfase: Clockinput (SPI)
Input ICE interfase data input (JTAG)
Input Serial host interfase: Serialdata input (SPI)
— Ground pin
Input/Output Group A serial port clock input /output
Input/Output Group A serial port (for input) word selection or frame synchronous input/output
Used to connect a power supply of +3.3V ±5%
—
Input Data input for serial ports A, E and F
Input/Output Word selection input/output for the group B serialport
Input/Output Data bus
Input/Output Grop B serial port clock input/output
Input/Output Data bus
Output Serial port G data output digital audio interface output terminal
Input/Output Data bus
Function
– 42 –