Advertisement
ADJUSTMENT OF PROJECTION POSITION
1.
Carry out horizontal and vertical adjustments as follows:
(1) To adjust the horizontal position of the screen, loosen rotary setscrews [E] (there are two pieces on both sides) and 4 hexagon
socket bolts (M5
10), and rotate the projector horizontally.
(2) To adjust the vertical position of the screen, loosen the assembling bolts (there are 4 pieces on both sides), then tilt the front of the
projector vertically.
2.
Tighten the rotary setscrews [E], hexagon socket bolts (M5
Fig. 5 ADJUSTMENT
Tip of LCD Projector ~ Center of ceiling plate
Unit of indicated dimensions (mm)
FILTER CLEANING
Before replacing the filter, never forget to turn
OFF the main power switch and unplug the
power cord from the outlet.
1.
Remove the 2 filter guard fixing screws,
and remove the filter guard.
2.
Push the knob of the filter cover in the
direction indicated by the arrow mark, and
raise it.
3.
Take out the filter, wash it well in water or
synthetic detergent, and dry it completely.
4.
Set the filter on the filter cover, and install
the filter cover on the body.
5.
Tighten 2 filter guard fixing screws, then
set the filter guard.
Hexagon wrench
(accessory)
Rotary setscrew [E]
Assembling bolt for M8
Lens center
Tilt adjusting latitude
of 15 degrees
(Carry out filter cleaning with appropriate intervals)
Fig. 6 REPLACEMENT
2 filter guard
fixing screws
(Refer to Fig. 5)
10), assembling bolts, and fix the LCD projector.
Assembling bolt
(M8
25)
148
339
367
Filter guard
Filter cover
– 4 –
Printed in Japan
0999YMPS/VP
VICTOR COMPANY OF JAPAN, LIMITED
Filter
Advertisement
