Entering And Changing Contacts And Coils - Eaton MFD-Titan Operating Instructions Manual

4 Wiring with MFD
4.7 Working with contacts and relays

4.7.1 Entering and changing contacts and coils

4.7.1.1 Contacts
I 02
Contact name
Contact number
3I02
Station address
Contact name
Contact number
CP01GT
Contact name
Contact number
(= function block number)
Contact function
2RN02
Station address
Contact name
Contact number
166
Manual 11/10 MN05002001Z-EN www.eaton.com
The following describes how you wire the different contacts and coils of
different relay types or function blocks (inputs) in the circuit diagram.
You choose an input contact in the MFD device by means of the contact
name and the contact number.
Example: Input contact basic device
or
Example: Input contact via NET (here from NET station 3)
The contact of a function block consists of the abbreviated function block
name, the number and the contact function.
Example: Contact of "comparator" function block
How a safety or standard function block is added to the circuit diagram and
parameterized is described in ￫ Section "4.9 Working with function blocks"
on page 188.
If the contact of an Net station is used in the circuit diagram, the NET ID
(address) of the station is placed in front of the contact name, ￫ section
"4.7.12.1 Setting the NET ID of a NET operand", page 179.
Example: Contact of a NET station