Honeywell T7200 Owner's Manual page 17

KEYS USED FOR SETTING THE START TIMES
TO SET OCCUPIED AND
UNOCCUPIED START TIMES
1. Press the SELECT DAY key. The display will
show an abbreviated day of the week.
2. Press the + or - key until the desired day is dis-
played.
3. Press the OCCUPIED START TIME key. The
indicator on the display will point to OCCUPIED,
indicating that the OCCUPIED period has been
selected.-
4. Press the + or - key until the desired start time
appears on the display.
5. If the occupied time displayed is not desired,
press the CLEAR START TIME key.
6. Press the UNOC START TIME key. The indicator
on the display will point to UNOCCUPIED, indicating
that the UNOCCUPIED period has been selected.
7. Press the + or - kev until the desired start time
appears on the display.
8. If the unoccupied start time displayed is not
desired, press the CLEAR START TIME key.
NOTES:
To program a second Occupied Start Time for the
selected day, repeat step 3 until either 4 dashes
(----) are displayed, or the second start time (if
previously programmed) is displayed. Then repeat
step 4.
To program a second Unoccupied Start Time for
the selected day, repeat step 6 until either 4 dashes
(----) are displayed, or the second start time (if
previously programmed) is displayed. Then repeat
step 7.
Repeat Steps 1 through 8 for each remaining day of
the week, or refer to the section titled TO COPY
A DAY.
Program times are entered in lo-minute increments.
Each day of week has two OCCUPIED START
TIME and two UNOCCUPIED START TIME slots
available for programming.
Each "day" is the 24-hour period from 12 a.m. to
12 a.m. (midnight to midnight).
33